High-Pressure Tanning

Legend has it that the first two high-pressure systems in the United States were sold in 1975 by Dr. Müller to the Playboy magazine organization. Others claim that the first system was developed by Dr. Maxim Mutzhas and that the first commercial high-pressure tanning system was installed in a tanning salon in New York City in 1976.

There is no way to resolve this debate as to what came first; however, there is no disagreement that the development of the high-pressure tanning system occurred in Germany.

Because these first systems were so expensive and there was no developed indoor tanning industry (many of the early tanning units were home-made), only a handful of these early high-pressure systems were sold in the 1970s and 1980s in the U.S. market.

High-pressure equipment hit the U.S. shores in the early 1980s; however, its growth was hindered because of the equipment’s high cost and the fact that the American tanning market was still in its infancy. By the 1990s, high pressure began to make a name for itself in the United States, and today it has become a mainstay in a salon’s equipment mix.

High-pressure tanning systems utilize lamps filled with mercury vapors that produce very high UVR intensity levels. Special filters are used to remove unwanted wavelengths of UVR, primarily UVB and shorter wavelengths of UVA (320 nm-340 nm), leaving most of the longer wavelengths of UVA (340 nm-400 nm) intact. This allows the high-pressure spectrum to produce a deeper, darker, longer-lasting tan.

Research supports the fact that high-pressure systems do provide a deeper, darker and longer-lasting tan when compared to low-pressure systems. This occurs because longer wavelengths of UVA penetrate deeper into the skin than do shorter wavelengths of UVA and UVB wavelengths and, therefore, are able to oxidize melanin granules farther away from the surface of the skin. These deeper-oxidized granules take longer to reach the surface of the skin and allow for a deeper tan with a longer life.

It must be mentioned that greater care should be exercised when tanning anyone who is most sensitive to UVR (that goes for high-pressure as well as low-pressure tanning). All tanners who frequent a tanning salon will have a pre-established level of sensitivity to UVR. Therefore, if they are overexposed to UVR, whether on a high- or low-pressure system, they will burn.

Manufacturers are taking design and engineering to the next level by offering stylish-looking equipment featuring the latest technological advancements. Keeping luxury in the forefront of the tanning experience, high-pressure units continue to offer comfortable and large tanning surfaces. Some units feature bells and whistles, including mattresses that feature massage options and aromatherapy, to provide tanners with a more enjoyable and relaxing session.