Reinforcing The Eyewear Issue
We’ve discussed some potential hazards and conditions
resulting from tanning without eye protection and tanning with contaminated
eyewear, including pinkeye, impetigo, viral or bacterial infections, cold sores,
corneal burns and brunescent cataracts.
The following discusses other eye diseases that can creep into
your tanning salon and have a dramatic, negative impact on your business. By
understanding their symptoms and indicators you can identify these types of
infections quickly.
Molluscum Contagiosum
This
superficial skin infection is caused by a poxvirus. Close physical contact
usually is necessary for transmission; however, indirect transmission from
shared towels, eyewear and swimming pools can cause contact with the infection.
The incubation period varies from several weeks to several
months, and symptoms include small, discrete, round pearly white growths on the
skin. Common sites of the infection are the eyelids, neck, trunk and anogenital
areas. The growths can measure between 2-5 mm and their sunken centers contain a
white, curdy-type material. The bumps often remain unchanged for many months,
after which they disappear; however, shaving or scratching may cause the
infection to spread.
Blepharitis
Blepharitis is a chronic
inflammation of the eyelids that causes swelling, itching and irritation. There
are two types— seborrheic and staphylococcus—which are common in both
children and adults.
Seborrheic blepharitis is associated with dandruff of the
scalp and may be part of an overall skin disease that also affects the chest,
back and behind the ears. The condition is characterized by redness of the
eyelids and scaling and flaking around the eyelashes. The glands of the eyelids
produce an abnormal quantity and quality of tear film that causes the formation
of greasy, waxy scales, which accumulate at the base of the eyelashes and flake
off easily. Several factors including hormones, nutrition, general physical
condition and stress may contribute to the development of this condition.
Staph blepharitis is a more severe condition that often begins
in childhood and continues through adulthood. Staph blepharitis is caused by
bacteria staphylococcus aureus, and it is characterized by matted, hard crusts
around the eyelashes. The crust can make opening the eyes in the morning
difficult. Removal of the crusts often leaves small ulcers, which bleed or ooze.
In some cases, a red eye may develop or a sty may form and a loss of lashes or
broken lashes can occur. If left untreated, staph blepharitis may lead to
infection and scarring of the cornea and other areas of the eye.
Herpes
Herpes simplex virus (HSV)
infections involving the eyelid can present in one of two forms. The classic
appearance involves an accumulation of small vesicles or pustules along the lid
margin and/or periocular skin. These lesions typically have an inflamed,
erythematous base. Within the first week of infection, the vesicles may ulcerate
or harden into crusts.
A second “erosive-ulcerative” form of HSV blepharitis
presents itself with erosions of the lid at the Gray line or ulcers along the
lid margin, or a combination of both. Typically, the lid displays generalized
swelling and redness associated with these lesions. Symptoms include pain and tenderness upon touch, as well as
increased lacrimation in severe cases. If the conjunctiva is involved, tarsal
follicles may be observed along with bulbar injection and chemosis. Swollen
pre-auricular nodes on the involved side are common.
The herpes virus, which causes cold sores, also can infect the
membranes of the eye. Herpes simplex keratitis causes inflammation of the white
of the eye and can damage the cornea. Herpes infection in the eye can cause
corneal scarring with vision loss.
Signs and symptoms include pain, red eye, tearing, light
sensitivity, irritation, scratchiness and decreased vision.
Protective Measures
Now that you’ve
increased your medical knowledge, there are a number of things you can do to
curb the risk of one of these diseases overtaking your salon.
The first and most obvious is to educate your staff about the
importance of providing clean, sanitized protective eyewear to each and every
tanner. FDA regulations require that not only must there be signs posted on the
equipment, but salon owners also must explain the proper use of protective
eyewear to every customer. Failure to comply puts the owner at risk of being
held liable in professional liability lawsuits.
Additionally, Texas is the only state that requires tanning
salons to offer the eyewear at no charge. Therefore, salons that suggest their
customers buy their own set of protective eyewear can increase their profits—especially
when they are being sold as an accessory clients need to preserve their own
personal health.
However, just because some tanners may have their own pair of
goggles, they still need to clean them. Heat from the tanning bed can build up
the bacteria in the goggle over time. Additionally, goggles should be kept in a sanitary container.
This is one obvious benefit of disposable eyewear—no chance
for infection. Disposable eyewear is completely sanitary because the tanner is
just wearing it once and then throwing it in the trash.
Whether the salon provides free disposable eyewear or goggles,
some salons are encouraging clients to purchase their own set of goggles each
and every time they tan.
The issue of eyewear is as important as any in the tanning
equation. Whether your salon offers goggles or disposables, you must make it
your mission to educate your staff and customers about the necessity of wearing
clean, protective eyewear each and every time they tan.
| Appendix A |
| Standards For Components |
| Standards under which components of the products covered
by this standard are judged include the following: |
| Title of Standard |
Standard Designation |
| Standards for Safety—Attachment Plugs and
Receptacles, Electrical |
UL 498 |
| Ballast, Fluorescent-Lamp |
UL 935 |
| Cord Sets and Power-Supply Cords |
UL 817 |
| Flexible Cord and Fixture Wire |
UL 62 |
| Lampholders, Edison-Base |
UL 496 |
| Lampholders, Starters, and Starter
Holders for Fluorescent Lamps |
UL 542 |
| Motor-Operated Appliances, Electric |
UL 73 |
| Polymeric Materials—Long Term Property
Evaluation |
UL 746B |
| Polymeric Materials—Short Term Property
Evaluation |
UL 746A |
| Polymeric Materials—Use in Electrical
Equipment Evaluations |
UL 746C |
| Sleeving, Coated Electrical |
UL 1441 |
| Switches, Clock-Operated |
UL 917 |
| Switches, Special-Use |
UL 1054 |
| Tape, Insulating |
UL 510 |
| Temperature-Indicating and Regulating
Equipment, Electrical |
UL 873 |
| Thermal Cutoffs for Use in Electrical
Appliances and Components |
UL 1020 |
| Tubing, Extruded Insulating |
UL 224 |
| Wire Connectors and Soldering Lugs for
Use With Copper Conductors |
UL 486A |
| Wire Connectors for Use With Aluminum
Conductors |
UL 486B |
| Wires and Cables, Rubber-Insulated |
UL 44 |
| Wires and Cables, Thermoplastic-Insulated |
UL 83 |
|